Questions about your User Interface (iPad) connecting up in your One Button Studio or Lightboard Studio from Revolution? Start by identifying which User Interface you have & clicking on the respective link. Does your User Interface have a ROUND home button with the cord on the right-hand side? Your updated instructions can be found here...

This procedure applies to User Interfaces which have no visible, circular home button on the right hand side.  If that does not match the description of your User Interface, return to here.  NOTE - Under normal operation, when the studio is OFF (white puck) - the system will show that it is attempting to reconnect. Once the studio has been turne...

This procedure applies to User Interfaces which have a both a visible, circular home button on the right hand side and a white cord plugged into the right side. If that does not match the description of your User Interface, return to here.  NOTE - Under normal operation, when the studio is OFF (via round white puck power controller/switch) - the...

Is your Flex monitor black, dark, or not showing anything? Below are the first steps the Revolution team would check. These steps apply to most studios purchased from Revolution since 2021 - please follow them in order, starting with 1: Confirm the studio is ON, via the white (or similar) power controller, sometimes referred to as the "puck." V...

Is the desk with your Revolution studio or lightboard not moving (not raising up nor down)? No worries - this is a common question with a straightforward solution. The desks have an internal position monitoring system and it's likely it just needs to be reset. Occasionally, this reset may be required after a power outage or similar incident. Ple...

Configure dScribe Studio PC On the dScribe Studio PC, open the Microsoft Store. You can find the program by typing Microsoft Store into the bottom search bar and clicking the option when it shows up. When the store opens up, type in the top search bar Wireless Display. When the option becomes available, click on Microsoft Wireless Display Adap...

***If you are unsure if you have a Gen 3 Lightboard Studio (2023-), please contact Revolution at 563-949-1160. If you'd like to increase the volume of your lightboard studio recordings, please see the steps below. Locate the audio interface (image below) The default positioning of the dial should be at approximately 2/3s from the lowest positi...

***If you are unsure if you have Logo ON/OFF capabilities on your Revolution studio, please contact Revolution at 563-949-1160. If you'd like to update the logo available on the studio, please see the steps below. Prepare the Logo Locate a logo that you would like to use for your institution. Ideally, the logo would have a transparent backgrou...