This procedure applies to User Interfaces which have no visible, circular home button on the right hand side.  If that does not match the description of your User Interface, return to here. 

NOTE - Under normal operation, when the studio is OFF (white puck) - the system will show that it is attempting to reconnect. Once the studio has been turned ON (white puck), it will attempt to reconnect.

In the case the studio is not connecting, follow the steps below:

Verify that Wi-Fi is NOT 'ON' on in the user interface (an iPad). Turn 'OFF' if it is. If Wi-Fi is turned on, that will 100% prevent the connection we need. 

Then, power cycle the studio via the round white switch. 
To do this, press OFF on the white switch. 
Wait a full 30 seconds. Then turn ON. Wait a full 30 seconds. 
If this does NOT remedy the issue, try a second time. If that doesn't work, proceed to the steps below. 

1. If the computer is running, shut down the computer
2. Turn studio OFF with white power puck.
3. Unplug cord from iPad/User Interface. (the iPad can continue to run)
4. Unplug entire system from power outlet.
5. Wait 60 seconds.
6. Plug in entire system to power outlet.
7. Plug in cord from iPad/User Interface.
8. Turn studio ON using white power puck.